Adjust parameter MON1 to level 1 and MON2 to level 0. The three-digit LED display will then show the fault code. A normal display shows 000; if a fault occurs, a three-digit code will appear. Refer to the fault code table for troubleshooting and repair.
Magnetic learning operation procedure: First, stop the car at a floor in the middle of the shaft. Set SATE1 to level 0 and SATE0 to level D. Then, press the SW1 button twice consecutively. The screen will display "P" followed by two digits, indicating that the magnetic learning mode has been entered. Next, operate the elevator up and down using the maintenance handle. The equipment will automatically complete the learning process, and the screen will display the floor number, indicating that the learning is complete. Finally, adjust SATE1 back to level 0 and SATE0 to level 8. Press the SW1 button twice again to exit the learning mode.
